QuickTrick Alignment Turn Plates
Measuring Range -20 to +20 degrees
$525.00Sold Out - Backorder Available
QuickTrick Alignment Turn Plates Pt No 60004
QuickTrick Alignment Turn Plate Measuring Range -20 to +20 degrees
QuickTrick Alignment turn plates are only 8mm (5/16") thick, with means you can roll on and off with no side bind, no jacking the car up or lowering it down. Made from high quality steel and ball bearings for an easier turn they can hold up to 680kgs (1500lbs) weight capacity.
The turn plates are clearly marked 0, 10, 15, 20 degrees with 1 degree increments in between. The degree decals are magnetic so you can put them on where needed to ensure accurate measurement anywhere.
Each plate weighs 4.98kgs (11lbs) and has a powder coated finish with a smooth handle cut into each. Each turn plate is specially coated on the bottom to prevent slippage.
The kit comes complete with
- 2 x Turn Plates
- 2 x Magnetic Decals
- 1 x Instructions
QuickTrick Alignment Systems FAQs
1. What is the make-up of the QuickTrick system
QuickTrick Alignment systems are manufactured in the USA from US Steel/Cold Rolled tubing and Hot Angle. They are measured, cut, prepped and powder coated in our shop and then squared again and assembled for delivery!
2. How accurate are the QuickTrick digital gauges?
The digital gauge is accurate to within 1/10th of 1 degree. The toe system is as accurate as you read the tape measure. After checking the alignment on some of our vehicles, we have had them rechecked on various Full Scale Electronic Alignment systems and found our setup to be within 0.003 degrees on camber and 1/64 of an inch on toe.
3. How long does it take to set up a QuickTrick alignment system?
Less than 5 minutes. Make sure you use scotch blue to protect your wheels from the sharp edges. All of our systems come with simple and easy to understand instructions and there are plenty of video how to’s on the QuickTrick Alignment site.
4. Do i need special training to check my alignment or adjust it using the QuickTrick system?
NO AND YES! Special training is not needed to check your alignment. If you know the spec’s of your vehicle, checking your alignment can be performed in less than 5 minutes. As far as adjusting your alignment, this differs from one manufacturer to another, but again, we can offer suggestions and tips on any vehicle depending on the outcome you are looking to achieve.
5. Do QuickTrick alignments have to be performed on a perfectly level surface?
NO, Our QuickTrick Gauge features a calibration button to zero that will level and compensate for any unlevel surface. (With the exception of grass or mud.)
6. The QuickTrick alignment system looks so simple, does it really work?
YES, Checking your alignment is not rocket science. Alignment is simply angles and dimensions for caster, camber & toe. Although our system does not look like an $80,000.00 alignment machine, you can achieve the same results in a fraction of the time and cost without going to a shop or taking up all that space if you own a shop. QuickTrick Alignment Systems are affordable and cost effective.
7. Can this system be used on both front and rear?
Yes! The QuickTrick Systems will work on any front or rear wheel drive vehicle. You can use the QuickTrick System for checking and setting alignment for the front and also the rear suspension of your vehicle. You can also check front to rear alignment of your vehicle. Your QuickTrick Alignment system will work on most vehicle makes and models.
Be The First To Review This Product!
Help other American Speed users shop smarter by writing reviews for products you have purchased.